Release Notes for EN4M - Main Firmware

This article lists the release notes of the EN4M (Main Processor) Firmware (500-1032). This firmware controls the major functions of PBS operation.

This firmware is no longer being developed. However, the latest firmware can be found at this link:

EN4M Firmware

Product applicability

Applies to model EN4 PBS (Push Button Station for 4W EZComm Navigator) only.

EN4 (EOL)

Filename: 500-1032XZZ.en4m (X is the Major Value, ZZ is the Revision Value).

Note: Firmware can only be updated using the EZ APS ToolBox PC application and a USB (Type A to B) cable plugged directly into the bottom of the EN4.


EN4M v3.12 (2016-11-28)

Critical Update

  • EN4M Firmware
  • Fix Extended Push lost when interrupted by start of Walk
  • Fix Ped call hold time not working, extend to 250ms

EN4M v3.11 (2013-04-02)

  • Add support for counting Extended Pushes
  • Built in switches for External Speaker and Migma option switches located near top of restart section
  • Migma version is EN4MS01391
  • External speaker version is EN4MES360

EN4M v3.10 (2012-07-31)

  • Convert to PicBasic Pro 3.0, add #CONFIG section
  • Fix playtimer not set at play time
  • Fix AP reset to prevent silent hang
  • Fix to respond to External Extended Push during Walk rest mode
  • Fix PSM fault if configurator starts during Walk
  • Remove Migma feature - will be special option only
  • Turn off walkonpin before ap reset
  • Add playtimer to prevent lockup if no playing signal
  • Turn on walkonpin after reset if in Walk
  • Add new operating feature - play "wait" with external button - Migma feature
  • With set active config by calendar, only write eeprom when config actually changes

EN4M v3.07 (2011-11-09)

  • Fix locate tone 3 plays tone 4
  • Fix pingpong not working - bit variables should have been changed to bytes
  • Add delay time before button enable at beginning of walk rest mode
  • Change button delay time to 0.5 second

EN4M v3.05 (2011-10-07)

  • Add clearing of locateflag to fix long tactile pulse

EN4M v3.04 (2011-08-01)

  • Fix bug caused by 3.02 - button disabled if clearance is skipped

EN4M v3.03 (2011-07-28)

  • Do PSM test only on command $1b from ap
  • Add code to clear locked ped call, do PSM test with either pwr-on reset or brn-out reset

EN4M v3.01 (2011-07-19)

Initial Release

  • Change version for initial release to New York
Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.